beautypg.com

Appn configuration commands – IBM SC30-3865-04 User Manual

Page 183

background image

Table 23. Configuration Parameter List - Link Station - Detail (continued)

Parameter Information

Parameter

fully-qualified CP name of adjacent node

Valid Values

A string of up to 17 characters in the form of

netID.CPname

, where:

v

netID

is a network ID from 1 to 8 characters

v

CPname

is a control point name from 1 to 8 characters

Each name must conform to the following rules:

v

First character: A to Z

v

Second to eighth characters: A to Z, 0 to 9

Note: An existing fully-qualified CP name, using the special characters @, $, and from
the character set A, continues to be supported; however, these characters should not
be used for new CP names.

Default Value

None

Description

This parameter specifies the fully-qualified CP name of the adjacent node. For the
cases where this parameter is not required, the adjacent node’s CP name may be
learned dynamically during XID exchange; however, if a CP name is specified, it must
match the adjacent node’s definition for the link to be successfully activated.
Note: This parameter is required when any of the following occur:

v

The

Service any node

parameter is set to Disable.

v

The

Adjacent node type

parameter is set to LEN end node.

v

The

CP-CP session level security

parameter is set to Enable.

v

The link is a limited resource.

Parameter

Activate link automatically

If limited resource, then this parameter is set to No and is not configurable.

Valid Values

Yes, No

Default Value

Yes

Description

When this parameter is enabled, the router network node automatically activates the
link to the adjacent node and initiates a connection.

APPN Configuration Commands

Chapter 2. Configuring and Monitoring APPN

153