IBM SC30-3865-04 - Manual (Page 216)

will be shown in square brackets [ ].
Table 35. Configuration Parameter List - APPN Implicit Focal Point
Parameter Information
Parameter
focal point
Valid Values
A fully-qualified CP name
Default Value
Blanks
Description
This parameter specifies the fully-qualified CP name representing this focal point.
The first focal point added is the primary implicit focal point. Up to 8 additional backup
implicit focal points may be added by invoking Add focal_point multiple times. If the
primary implicit focal point is taken off the focal point list with Delete focal_point, the
first backup implicit focal point, if there is one, becomes the primary implicit focal point.
Syntax:
add local-pu
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Table 36. Configuration Parameter List - APPN Local PU
Parameter Information
Parameter
Station name
Valid Values
A string of 1 to 8 characters:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Default Value
None
Description
This parameter specifies the name representing the link between the DLUR and the
PU.
APPN Configuration Commands
186 MRS V3.2 Protocol Config Ref Vol 2