IBM SC30-3865-04 - Manual (Page 442)

Example:
PIM6 Config> delete
Interface address []?
Disable
Use the disable command to disable PIM on the device.
Syntax:
disable
Enable
Use the enable command to enable PIM on the device and set global PIM default
configuration values.
Syntax:
enable
List
Use the list command to display the PIM configuration.
Syntax:
list all
interface
preference
variables
all Displays all PIM configuration information.
interface
Displays PIM configuration information about the currently configured
interfaces.
Example:
PIM config>list i
Hello State
Type IP Address Interval Holdtime
Physical 1:2:3:4:5::101 30 210
Type Identifies the type of interface that is configured.
IP address
Identifies the IPv6 address assigned to this interface.
Hello Interval
Identifies the interval between hello messages, in seconds, sent on
this interface.
State holdtime
Identifies the number of seconds to tell other devices upstream to
hold PIM state for this device. For PIM, this is the amount of time
for upstream devices to keep prunes alive.
PIM Configuration Commands (Talk 6)
412 MRS V3.2 Protocol Config Ref Vol 2
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
||
||
||
||
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|