IBM SC30-3865-04 - Manual (Page 192)

Table 24. Configuration Parameter List - Station Configuration for ATM (continued)
Parameter Information
Parameter
Broadband Bearer Class
Valid Values
Class_A, Class_C, Class_X
Default Value
Class_X
Description
This parameter specifies the bearer class requested from the ATM network. The
classes are defined:
Class A
Constant bit rate (CBR) with end-to-end timing requirements
Class C
Variable bit rate (VBR) with no end-to-end timing requirements
Class X
Service allowing user-defined traffic type and timing requirements
Parameter
Best Effort Indicator
Valid Values
Yes, No
Default Value
No
Description
This parameter indicates if a throughput guarantee is required on this SVC. If the value
of this parameter is
yes , then VCCs associated with this interface will be allocated
based upon the available bandwidth.
Note: The following parameters are forward traffic parameters.
Parameter
Forward Peak Cell Rate
Valid Values
85% of line speed
Default Value
Port’s Default Effective Capacity/48
Description
This parameter indicates an upper bound on the cell transmission rate.
APPN Configuration Commands
162 MRS V3.2 Protocol Config Ref Vol 2