IBM SC30-3865-04 - Manual (Page 84)

0 TR000 IBMTRNET YES YES YES
1 PPP001 PPP YES YES YES
2 SS SDLC NO YES YES
3 SDLC NO YES NO
4 PPP YES YES NO
5 TR005 IBMTRNET YES YES YES
254 DLS NO YES NO
17 PPP017 PPP YES YES YES
9 PPP009 PPP YES YES YES 6
STATION:
STATION PORT DESTINATION HPR ALLOW ADJ NODE
NAME NAME ADDRESS ENABLED CP-CP TYPE
------------------------------------------------------------
TONN1 TR000 0004AC4E7505 YES YES 1
TONN2 TR000 550020004020 YES YES 1
TONN9 TR000 0004AC4E951D YES YES 1
TOPC4 TR000 0004AC9416B4 YES YES 1
TOVTAM1 TR000 400000003888 YES YES 1
TONN35 PPP001 000000000000 YES YES 0
TO15DOD PPP009 000000000000 YES NO 0 7
LU NAME:
LU NAME STATION NAME CP NAME
------------------------------------------------------------
Note:
1 Idle timer > 0 means dial on demand
2 This is a limited resource
3 TG number is required for a limited resource
4 Do not allow CP-CP sessions on this link
5 Provide a fully-qualified CP name
6 This is the port
7 This is the link station
Configuring WAN Reroute
WAN reroute lets you set up an alternate route so that if a primary link fails, the
router automatically initiates a new connection to the destination through the
alternate route.
You can use any type of link as the alternate link and any type of link as the
primary link. The alternate link does not need to be connected to the same end
point as the primary link.
If HPR is used on the primary link and alternate link, when the primary link fails,
HPR’s Non-disruptive Path Switch function will automatically reroute traffic to the
alternate link without disrupting end user sessions.
In this configuration example, the router performing the WAN reroute function is
configured with two APPN link station definitions; one link station is defined over the
primary interface and the other is over the alternate interface. The destination router
needs to have APPN enabled on the port. If the destination router has a link station
defined, that link station should not try to bring up the connection in order to avoid
extra traffic.
In this example, frame relay is the primary route from NN22 to NN6.
*************************************************************************
**** The configuration is NN22---primary FR
**** ---Alternate WRR to NN6
*************************************************************************
****
**** This is the NN22 configuration
*************************************************************************
Ifc 0 Token Ring CSR 6000000, vector 28
APPN
54 MRS V3.2 Protocol Config Ref Vol 2