Next – Sharp MX-6070N User Manual
Page 897
7-182
SYSTEM SETTINGS►SETTING MODE FOR FAX
Activity Report Print Select Setting
You can set the machine to periodically print the activity report that is stored in memory.
The Image Sending Activity Report can be set to print each time the number of transactions reaches 200, or at a specified
time (once a day only). (The settings can be simultaneously enabled.)
ECM
When you send a fax, noise on the line may occasionally cause distortion of the image. You can enable ECM (Error
Correction Mode) to automatically resend only the part of the image that was distorted.
Digital Line Network
When this setting is enabled, the send level will be 15 dB or less when you connect to a digital line.
Distinctive Ring Detection
This Setting can only be activated in Canada, Australia, New Zealand, and Hong Kong.
If multiple telephone numbers have been assigned to your telephone line, the number called can be identified by its
ringing pattern. By using one number for voice calls and another number for faxes, you can tell which type of call you are
receiving by the ringing pattern. You can set your machine to automatically receive faxes when your fax number is called
by setting the pattern that corresponds to your fax number. (Note that in Canada, six selections are available.)
PBX Setting
This Setting can only be activated in France and Germany.
When the machine is used on a PBX, you can enable the PBX setting to have the machine automatically connect to the
outside line. When this setting is enabled, the [R] key appears in the base screen. When the [R] key is touched, the PBX
setting is temporarily cancelled.
If your PBX uses the Flash method to connect to the outside line, select the [Flash]. If your PBX uses an ID number to
connect to the outside line, specify the ID number.
• If you only select the "Print Daily at Designated Time" setting
and the number of recorded transactions reaches 200
before the specified time, each new transaction will delete the oldest transaction (the oldest transaction will not be printed).
• The Transaction Report can be printed out manually as needed. For more information, see "
".
If the receiving machine is a Super G3 machine, ECM will always operate, regardless of this setting.
Select a number for the first digit and then a number or a hyphen "-" for the second and third digits.