Sharp MX-6070N - Manual (Page 529)

4-126
FACSIMILE►CHECK THE COMMUNICATION STATUS
Examples of messages that are printed in the result column
Print Page Description
Yes The transaction was completed normally.
G3 Communication took place in G3 mode.
ECM Communication took place in G3 ECM mode.
SG3 Communication took place in Super G3 mode.
Forward The received data was forwarded.
No Response No response from the receiving party.
Busy Transmission was not possible because the other party was already using the line.
No The transmission was cancelled while in progress.
MEMORY OVER The memory became full during quick on-line transmission.
FULL The memory became full during reception.
LENGTH OVER The transmitted fax was over 59" (1.5 m) long and therefore could not be received.
ORIGINAL ERROR Direct transmission or manual transmission was not successful because a misfeed occurred.
PASS# NG The connection was broken because the polling passcode was not correct.
NO RX POLL The machine that was polled does not have a polling function.
RX POLL FAIL
The other machine refused the polling operation, or your machine broke the connection when
polled because no data was in memory.
NO F-CODE POLL
The other machine refused an F-code polling operation, or your machine broke the
connection when polled because no data was in its F-code memory polling box.
RX POLL# NG
The connection was broken because the sub-address for F-code polling memory was not
valid.
F POLL PASS# NG The connection was broken because the passcode for F-code polling memory was not valid.
BOX NO. NG
Your machine broke the connection because the specified sub-address for an F-code
memory box does not exist.
F PASS# NG
Your machine broke the connection because the other machine sent an incorrect passcode
for F-code communication.
RX NO F-CODE POLL
F-code polling was attempted, however, the other machine did not have an F-code polling
memory box.
NO F FUNC
F-code communication was attempted, however, the other machine does not support F-code
communication.
NO F-CODE
F-code communication was refused by the other machine because of an incorrect
sub-address or other reason.
M. BOX: [xxxxxx] ******
Data was received and stored in a confidential or relay broadcast memory box, or data was
sent from a memory polling box.
The name of the memory box appears in [xxxxxx], and the type of F-code operation (relay
request reception, polling memory transmission, or confidential reception) appears in ******.
FAIL xx (xxxx)
The transaction failed due to a communication error.
First 2 digits of communication error number: Error code from 00 to 99.
Last 4 digits of communication error number: Code for use by service technicians.
Rejected A fax was sent from a party from which reception is blocked.