Common settings -120, Paper settings -120, Common settings – Sharp MX-6070N User Manual
Page 835: Paper settings, Paper tray settings
7-120
SYSTEM SETTINGS►SYSTEM SETTINGS
Common Settings
Paper Settings
Paper Tray Settings
Paper tray and paper type settings are explained in this section.
These settings specify the paper type, paper size, and functions allowed for each paper tray.
When [Paper Tray Settings] is selected, a list appears showing the trays and the current settings.
Auto Switching of Tray
When a tray runs out of paper during printing, this determines whether or not another tray with the same size and type of
paper is automatically selected and printing continues.
Display Paper Tray Settings when bypass tray detects paper.
You can have the paper tray settings appear automatically when paper is detected in the bypass tray.
Settings of each tray
When the [Change] key is tapped, the corresponding setting screen appears.
The following settings can be configured.
List name
Description
Type
Select a type of paper to be loaded into the tray.
The paper types that can be selected vary by paper tray. For more information, see "
To user type setup, see "
Paper Type Registration (page 7-122)
Size
Select the paper size from the list. The paper sizes that can be selected vary by tray. The
sizes that can be selected may also be restricted by the paper type selected above. For
more information, see "
If the desired size does not appear in the list, select [Custom Size] and directly enter the
size (only for the bypass tray). For more information, see "
Sending Address List
Select the modes that can be used. If there is a function that you do not wish to be used
with the selected tray, disable the function.
When the "Type" is other than plain paper, recycled paper, coloured paper, or a user type,
[Fax] and [Internet Fax] cannot be selected.
• If the paper size specified here is different from the size of paper that is loaded into a tray, a problem or misfeed may occur
when printing.
• To change the paper size in a tray, see "
".
• Paper properties such as "Fixed Paper Side" are automatically set when the paper type is selected. The paper tray
properties cannot be changed in this screen.
• If [System Settings] in "Settings" → [Common Settings] → [Device Control] → [Disabling of Tray Settings] is selected, the
tray settings (except for the bypass tray) cannot be configured.
• Tray settings can only be changed in setting mode of the machine.