Sharp MX-6070N - Manual (Page 872)

7-157
SYSTEM SETTINGS►SYSTEM SETTINGS
IPsec Rules
The registered IPsec rules are displayed.
To add a new rule, click the [Add] key.
To delete a rule, select the rule you want to delete and click the [Delete] key.
IPsec Rule Registration
Rule Name
Enter a name for the IPsec rule.
Priority
Set the priority level.
Select the Rule Name to be the Registration Model
If there is a previously registered rule that is similar to the rule you want to create, you can create the new rule based on
the registered rule.
Device Address
Set the type of IP address to be used on the machine and the port number (for IPv6, set the port number / prefix length).
Client Address
Set the destination IP address type and port number (for IPv6, set the port number / prefix length).
Communication Type
Set the communication type used for IPsec.
Protocol
Set the protocol to be used.
Filter Mode
Set the filter to be used for IPsec.
IPsec Encryption
Configure settings for the authentication method used for IPsec.
ESP
Select to use ESP authentication.
Allow Communication not using ESP
Specify whether or not communication that does not use ESP is allowed.
AH
Select to use AH authentication.
Allow Communication not using AH
Specify whether or not communication that does not use AH is allowed.
IEEE802.1X Setting
IEEE802.1X can be used to authenticate a user to allow use of the machine.
IEEE802.1X protocol defines port-based authentication for both wired and wireless networks.
Use IEEE802.1X authentication to allow only authenticated devices to use network, and protect against network abuse
by third parties.
You can enable or disable IEEE802.1X authentication with this setting. The IEEE802.1X details can be set with Setting
mode (Web version). Depending on the Web page settings, connection to the machine may not be allowed, or the
settings may not allow printing, scanning, or Setting mode (Web version) display. In this case, deselect this setting and
change the Setting mode (Web version) settings.
Condition Settings
IEEE802.1X Authentication
Set whether IEEE802.1X authentication is used.