Sharp MX-6070N - Manual (Page 895)

7-180
SYSTEM SETTINGS►SETTING MODE FOR FAX
*1 This function is not available in some countries and regions.
*2 When an inner finisher, finisher, finisher (large stacker), saddle stitch finisher or saddle stitch finisher (large stacker) is installed.
*3 When the number of copies is set.
Image Send Settings
Fax Settings
You can select the image send settings of fax functions.Default Settings
The fax settings can be enabled or disabled to suit the needs of your workplace.
Resolution Setting
You can select the resolution setting for faxes.
Apply the Resolution Set when Stored
Select this to use the resolution at which the fax was sent.
If you do not select [Apply the Resolution Set when Stored], the image will be stored at the resolution specified in the
pull-down menu.
Dial Mode Setting
This setting can only be activated in Canada and Taiwan.
Select the appropriate setting for your telephone line type.
Auto Wake Up Print
When the [Power] button is "Off" (but the main power switch is "On") and a fax is received, this function activates the
machine and prints the fax.
When this function is disabled, received faxes are not printed until the [Power] button is switched "On".
Pause Time Setting
Changes the length of pauses inserted in fax numbers.
If a hyphen (-) is entered when dialling or storing a fax number, a pause of 2 seconds is inserted.
It can be set between 1 and 15 seconds, in every 1 seconds.
Fax Dest. Confirmation Mode
This setting specifies whether or not a destination verification message is displayed when sending a fax in order to
prevent accidental transmission to the wrong destination.
‹ Polling Setting No Yes
• Set Fax Polling Security Enabled No Yes
‹ F-Code Memory Box – Yes Yes
● Fax Data Receive/Forward (Manual) (page 7-191) Yes Yes
X Fax Settings Yes Yes
‹ Receive Settings Auto Reception Yes Yes
‹ Multiple Set Print *3 Disabled Yes Yes
‹ Staple Disabled Yes Yes
‹ Forward Received Data – Yes Yes
Setup Items Factory default setting U A