Interior – Sharp MX-6070N User Manual
Page 8
1-5
BEFORE USING THE MACHINE►BEFORE USING THE MACHINE
INTERIOR
(1)
The main power switch
Use this switch to turn on the power for the machine.
When using the fax or Internet fax functions, always keep
this switch in the “
” position.
► TURNING ON THE POWER (page 1-10)
(2)
Toner cartridge
This cartridge contains toner.
When the toner in a cartridge runs out, replace with new
one.
► REPLACEMENT OF TONER CARTRIDGE (page
(3)
Waste toner box
This container collects excess toner that remains after
printing.
► REPLACING THE WASTE TONER BOX (page
(4)
Fusing unit
Heat is applied here to fuse the transferred image onto
the paper.
(5)
Transfer belt
During full colour printing, the toner images of the four
colours on the photoconductive drums are combined
together on the transfer belt.
During black and white printing, only the black toner
image is transferred onto the transfer belt.
(6)
Right side cover release lever
To remove a paper misfeed, pull and hold this lever up to
open the right side cover.
(7)
Right side cover
Open this cover to remove a paper misfeed.
(8)
Paper reversing section cover
This unit is used for reversing paper when 2-sided printing
is performed. Open this cover to remove a paper misfeed.
(9)
Waste toner box release button
Press this button when you need to release the waste
toner box lock to replace the waste toner box or clean the
laser unit.
► CLEANING THE LASER UNIT (page 1-149)
► REPLACING THE WASTE TONER BOX (page
(10) Handle
Pull this out and grasp it when moving the machine.
(11) A low stand/550 sheet paper drawer or stand/550/
2x550/3x550/550&2100 sheet paper drawer right-side cover
Open this to remove a paper misfeed in tray 2, 3 and 4.
(12) Paper tray right side cover
Open this to remove a paper misfeed in tray 1.
(1)
(3)
(7)
(6)
(8)
(4)
(5)
(9)
(2)
(10)(11)
(3)
(12)
(2)
MX-3050N/MX-3060N/MX-3070N/
MX-3550N/MX-3560N/MX-3570N/
MX-4050N/MX-4060N/MX-4070N
A service technician collects replaced waste toner
box.
The fusing unit is hot. Take care not to burn yourself
when removing a misfeed.
Do not touch or damage the transfer belt.
This may cause a defective image.