Sharp MX-6070N - Manual (Page 30)

1-27
BEFORE USING THE MACHINE►BEFORE USING THE MACHINE
Each Energy Save settings in System Setting is not applied when Eco mode is used.
AUTO POWER SHUT-OFF MODE
This mode turns off the power to the operation panel and the fusing unit, and makes the machine wait in the lowest
power consumption state.
Auto Power Shut-Off Timer will activate when the set duration of time elapses in waiting status without executing a job.
Compared to preheat mode, the power-saving rate is considerably higher but the wakeup time is longer.
The [Power Save] button blinks when the machine is in Auto Power Shut-Off Timer.
Auto Power Shut-Off Timer is also activated by pressing the [Power Save] button while the [Power Save] button is not lit.
This mode is cleared when print data is being received, fax data is being output, or when the [Power Save] button is
pressed while it is blinking.
A message appears 15 seconds before Auto Power Shut-Off Mode is entered.
To close the message and continue normal operation, tap the [Continue] button.
The message appears again 15 seconds before the end of the extension of normal operation time.
If no action is taken within 15 seconds after the message appears, the machine enters auto power shutoff mode.
As soon as the remote job is finished,
enter Auto power shut off mode. On On
Preheat Mode Setting 1min. 1min.
Turn off Panel Display during
pre-heat mode On On
Sleep Mode Power Level Low Power Low Power
To set mode settings
"Settings (administrator)" → select [System Settings] → [Energy Save] → [Eco Setting] → [Mode Setting].
To set Auto Power Shut-Off Timer:
In "Settings (administrator)", select [System Settings] → [Energy Save] → [Eco Setting] → [Auto Power Shut-Off].
To set display of the message:
In "Settings (administrator)", select [System Settings] → [Energy Save] → [Eco Setting] → [Display Message When
Extending Transition Time to Preheat/Auto Power Shut-Off Mode].
Function Custom Eco
[Power Save] button/indicator