Yaskawa FSP Amplifier FlexWorks - Manual (Page 229)

Parameter Reference
229
Pn500 Positioning Completed Width ref. units 0-250 7 5.5.3
Pn501 Zero Clamp Level rpm 0-10000 10 5.4.3
Pn502 Rotation Detection Level rpm 1-10000 20 5.5.5
Pn503
Speed Coincidence Signal
Output
Width
rpm 0-100 10 5.5.4
Pn504 NEAR Signal Width ref. units 1-250 7 5.5.8
Pn505 Overflow Level
256 ref.
units
1-32767 1024 6.2.1
Pn506
Brake Reference Servo OFF
Delay
Time
10 ms 0-50 0 5.4.4
Pn507
Brake Reference Output Speed
Level
rpm 0-10000 100 5.4.4
Pn508
Timing for Brake Reference
Output
during Motor Operation
10 ms 10-100 50 5.4.4
Pn509 Momentary Hold Time ms 20-1000 20 5.5.9
Pn50A* Input Signal Selections 1 — — 2100 5.3.3
Pn50B* Input Signal Selections 2 — — 6543 5.3.3
Pn50C* Input Signal Selections 3 — — 8888 5.3.3
Pn50D* Input Signal Selections 4 — — 8888 5.3.3
Pn50E* Output Signal Selections 1 — — 3211 5.3.4
Pn50F* Output Signal Selections 2 — — 0000 5.3.4
Pn510* Output Signal Selections 3 — — 0000 5.3.4
Pn511
Reserved parameter (Do not
change).
— — — —
Sequence Parameters
Pn512*
Reserved parameter (Do not
change.)
— — — —
Pn580 Zero clamp level mm / s 0-5000 10 —
Pn581 Motion detection level mm / s 1-5000 20 —
Pn582
Speed coincidence signal output
width
mm / s 0-5000 10 —
Linear Motor
Sequence
Parameters
Pn583
Brake reference output speed
level
mm / s 0-5000 100 —
Pn600
Regenerative Resistor
Capacity**
10 W
0 to
capacity ***
0 5.6.1
Other Para-
meters Pn601
Reserved parameter (Do not
change.)
— — — —
* After changing this parameter, cycle the main circuit and control power supplies to enable the new settings.
** Normally set to "0". When using an external regenerative resistor, set the capacity (W) of the regenerative resistor.
*** The upper limit is the maximum output capacity (W) of the servo amplifier.
Category
Parameter
Number
Name Unit
Setting
Range
Default
Setting
Reference