Yaskawa FSP Amplifier FlexWorks - Manual (Page 13)

System Requirements and Software Installation
13
2. System Requirements and Software
Installation
For optimum performance, FlexWorks requires:
♦ Computer: Pentium 166 MHz (Pentium II 350 MHz
recommended)
♦ At least 32 MB of RAM (64 MB recommended)
♦ A hard drive with at least 100 MB of free disk space
♦ Operating System:
Windows 95 OSR2 or later (IE4.01 Service Pack 2 or later)
Windows 98
Windows NT4.0 Service Pack 3 or later (IE4.01 Service Pack
2 or later)
Windows 2000
Windows Me
Windows XP
♦ Super VGA or better graphics display, minimum 256 colors
(65536 colors recommended)
♦ One node or more RS-232C or RS-422A I/F
♦ CD-ROM drive (for installation only)
The FlexWorks software is supplied on a CD. Before proceeding with
the installation procedure, close any applications that are open.
During the procedure, FlexWorks and its related files are installed
on your hard disk. If a previous version of FlexWorks is already
installed, the existing program is overwritten.
To install FlexWorks:
1. Insert the CD into the CD-ROM drive.
2. If the procedure does not start automatically (i.e., auto play
is not enabled) either:
Click Start | Run and type "D:\Install\SETUP" (where D:
is your CD drive), or
Using Windows Explorer, load the CD-ROM contents, and
double-click D:\Install\SETUP.EXE.
The installation screen is displayed, the installation
procedure commences and a message welcoming you to
FlexWorks is displayed.