Yaskawa FSP Amplifier FlexWorks - Manual (Page 217)

Error Messages
217
7. Error Messages
Error messages that may be generated by FlexWorks are listed
below together with a short description of each.
C ODE M ESSAGE D ESCRIPTION
1 Sequential buffer full Serial commands were sent to
the Sequential buffer at a rate
faster than the execution rate.
2 Immediate buffer full Serial commands were sent to
the Immediate buffer at a rate
faster than the execution rate.
4 Too many program lines or
invalid program line number
5 Message checksum error An incorrect checksum indicates
that an error occurred during
message transmission.
6 SET_VAR: Invalid variable index An invalid variable index has
been used in the SET_VAR
command.
7 Variable is read-only The position cannot be set to zero
while the motor is moving.
8 Wrong op code This command does not exist in
the command list.
9 Wrong motion mode for
SET_ZERO_POSITION command.
Set STOP_EX command before
This command cannot be
performed if the Motion
Command buffer is not empty, or
if a motion is in progress.
10 Reply buffer full The reply buffer is full because
the command GET_VAR has been
used at a very high rate.
11 Incomplete message received The time limit for the message to
be sent to FSP Amplifier via serial
communication has been
exceeded.
12 Message too long The size of a message sent to
FSP Amplifier via serial
communication is limited to 64
characters.