Yaskawa FSP Amplifier FlexWorks - Manual (Page 222)

Error Messages
222
C ODE M ESSAGE D ESCRIPTION
97 AF1: Power line open phase
98 A.A0: I/O board disconnected
99 A.08: This linear motor is not
supported. ((250*Pn199) /
Pn280) should be an integer
100 A.33: Wrong Input Power.
Amplifier is in AC input mode
(Pn001.2=0), but has DC input
or vice versa.
101 A.80: Position error
102
A.B3: Current detection error.
Please check motor power line
wiring.
103 A.C3: Encoder AB-phase
disconnection of encoder signal
line
104 A.C4: Encoder c-phase
disconnection of encoder signal
line
105 A.C5: Linear motor pole sensor
position detection error.
112 A91: Overload (warning)
113 A92: Regenerative overload
(warning)
128 Reference to invalid label or END
command is missing Program flow has been directed
to a non-existent label.
129 Command not applicable in this
programming mode
(Program/Immediate/Sequential) Not all commands are applicable
in all programming modes
(Program/Sequential/Immediate).
The specified command is not
applicable in this mode.
130 Cannot perform this motion with
present profile acceleration The requested motion cannot be
performed. The specified motion
time is too short for the specified
acceleration.
131 Cannot perform this motion with
present profile speed The required speed for this
motion is greater than the max.
motor speed. Set a lower motion