Delta Electronics DELTA DUP-B - Manual (Page 65)

Chapter 3 Creating and Editing Screens
Fig. 3-5-4 Open an old project in ScrEdit
3.5.3 Close
Close Project. Closes project by clicking File > Close.
If project didn’t get saved before issuing the command of closing project, the user will get
saving dialog box (Fig. 3-5-5) to remind the user of saving project. The user can press Yes
button to close the project.
Fig. 3-5-5 Saving dialog box
3.5.4 Save
Save the File. Save current project into hard disk with extension file “dop” by choosing File >
Save or clicking the Save icon , or pressing Ctrl + S. If the project is a new file, the Save as
dialog box will show up (Fig. 3-5-6). If the project is an old file, the Save function will perform
immediately and the Save as dialog box will not show up.
3-44 Revision May, 2010