Delta Electronics DELTA DUP-B - Manual (Page 168)

Chapter 3 Creating and Editing Screens
Revision May, 2010 3-147
Property Description of Static Graphic Element
Transparent
If Yes is selected, it indicates that this element will be displayed in
transparent color. It is usually used with the transparent color
setting of the element. Please refer to the following example
elements:
The transparent
color has not been
set yet. The element
transparent color
has been set.
The transparent
color of the whole
drawing has been
set.
Please note that if Yes option is selected (set to Transparent), the
foreground color option is disabled.
X Used to set X coordinate
Y Used to set Y coordinate
Width Used to set the element width
Height Used to set the element height
Example of Static Graphic element:
The designated read address = D100. The internal memory value and each state
should be as follows:
D100=0 D100=1 D100=2 D100=3 D100=4
3.8.9.2 Animated Graphic
Property Description of Animated Graphic Element
When HMI is connected to PLC, the user can create animated graphic elements to read
the value of several read addresses controlled by PLC. The read value of each state can
be converted and transmitted to the animated graphic elements and display on the
HMI screen. The individual movement and moving position can also be controlled and
show on the HMI screen.
Read Address
The address can be internal memory or the controller address.
(Please refer to Table 3.2.2 Property Description of General
Buttons.)