Delta Electronics DELTA DUP-B - Manual (Page 124)

Chapter 3 Creating and Editing Screens
Revision May, 2010 3-103
Property Description of Set Value Buttons
It provides different kinds of data format for
different data length:
Word Double Word
Data Format
1. BCD
2. Signed BCD
3. Signed Decimal
4. Unsigned Decimal
5. Hex
6. Binary 1. BCD
2. Signed BCD
3. Signed Decimal
4. Unsigned Decimal
5. Hex
6. Binary
7. Floating
Integral Digits
Fractional Digits
Determine the digit number of integer and
decimal fraction. The digit number is not a real
digit number value. It is only the display
format. The digit number will be a real decimal
number only when the data format is selected
as Floating.
Range Setting
Press OK when you have input the minimum and maximum value,
and then HMI will examine the value by referring to the selected
data length, data format, and integral and fractional digits.
User Security Level
Use this option to set the user priority for pressing this element.
Only the priority that is equal to or higher than the current setting
can use this element.
Set Low Security
Use this option to force the current priority to be the lowest after
the button is pressed. This can prevent the misoperation made by
the user (operator).
InterLock Address
InterLock Level
When InterLock Address is set to be ON or OFF (this is determined
by the property of “InterLock Level”), this button can be enabled.
Before Execute
Macro
If this option is set, when the user presses the button, the system
will execute the command of this macro first and then perform
the operation of this button. But, if the state of the button is not
triggered by pressing the button (via macro or external signal),
the command of this macro will not be executed.
After Execute Macro
If this option is set, when the user presses the button, the system
will perform the operation of this button first and then execute
the command of this macro. But, if the state of the button is not
triggered by pressing the button (via macro or external signal),
the command of this macro will not be executed.
Enable the
confirm window
When this option is set, an Action Confirm dialog box will appear
to prompt the user everytime when the button is pressed.