Delta Electronics DELTA DUP-B - Manual (Page 45)

Chapter 3 Creating and Editing Screens
3.4 Control Block and Status Block
For two-way communication between Delta DOP series HMI and all other brands of PLCs, the
address of the control block and status block must be defined. These settings are located in the
Configuration dialog box (Fig. 3-4-2) by clicking Options > Configuration (Fig. 3-4-1). For
more details on settings, please refer to the following descriptions.
Fig. 3-4-1 Clicking Configuration Command
Fig. 3-4-2 Configuration Dialog Box
3-24 Revision May, 2010