beautypg.com

1 ipmc debug console, Table 4-2, Faceplate serial interfaces – Artesyn ATCA-7480 Installation and Use (February 2015) User Manual

Page 93: Table 4-3, Ipmc debug console destination selection, Functional description

background image

Functional Description

ATCA-7480 Installation and Use (6806800T17A)

93

Serial Line Interface #1 (COM #1) and #2 (COM#2) destination

The serial line interface #1/ #2 can be routed either to the zone 3 connector or to the Faceplate.
Destination selection is through IPMC or SW2-1.

The serial line interface #1 provides two different routing options:

Glue Logic FPGA <=> RTM

Glue Logic FPGA <=> Faceplate

4.15.1 IPMC Debug Console

The IPMC Debug Console IF connection is normally routed to a 3-pin on-board header (RS232)
The IPMC Debug monitor terminal output can also be routed to the Faceplate. The IPMC Debug
Console is also available when the ATCA-7480 Payload is powered off.

Table 4-2 Faceplate Serial Interfaces

SW2.1

Connection

HIGH Switch 2.1 OFF
Default

Glue Logic FPGA COM1 to Faceplate
Glue Logic FPGA COM2 to RTM

LOW or Switch 2.1 ON

Glue Logic FPGA COM1 to RTM
Glue Logic FPGA COM2 to Faceplate

Table 4-3 IPMC Debug Console Destination Selection

SW2.2

Connection

SW2.2 OFF Default

Faceplate connected to Payload COM1/2
IPMC Debug Console at three Pin Header

SW2.2 ON

IPMC Debug Console to Faceplate

This manual is related to the following products: