Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 252)

Supported IPMI Commands
ATCA-7480 Installation and Use (6806800T17A) 252
8.3 Artesyn Embedded Technologies Specific
Commands
The Artesyn Embedded Technologies IPMC supports several commands which are not defined
in the IPMI or PICMG 3.0 specification but are introduced by Artesyn Embedded Technologies:
serial output commands.
8.3.1 Serial Output Commands
The firmware upgrade commands supported by the blade are implemented according to
the PICMG HPM.1 Revision 1.0 specification.
The boot block can be updated with PICMG HPM.1 specific commands.
 Before sending any of these commands, the shelf management software must check
whether the receiving IPMI controller supports Artesyn Embedded Technologies specific
IPMI commands by using the IPMI command, 'Get Device ID'. Sending Artesyn
Embedded Technologies specific commands to IPMI controllers which do not support
these IPMI commands will lead to no or undefined results.
 Proper handling of these commands is required to write a portable application.
Table 8-18 Serial Output Commands
Command Name NetFn (Request/Response) CMD Description
Set Serial Output 0x2E/0x2F 0x15 See Set Serial Output Command on
page 253
Get Serial Output 0x2E/0x2F 0x16 See Get Serial Output Command on
page 254