Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 234)

Supported IPMI Commands
ATCA-7480 Installation and Use (6806800T17A) 234
8.1.7.1.1 System Boot Options Parameter #96
This boot parameter is an Artesyn-specific OEM boot parameter. Its definition is given in the
following table.
8.1.7.1.2 System Boot Options Parameter #98
This boot parameter is an Artesyn-specific OEM parameter.
Timeout for graceful shutdown 98
BIOS boot parameters. 100
Table 8-8 Configurable System Boot Option Parameters (continued)
Configurable Boot Property Corresponding Boot Parameter Number
Table 8-9 System Boot Options Parameter #96
Data Byte Description
1 Bits 7:2: Reserved
Bit 1: FPGA configuration stream load
0: Load configuration stream from default boot flash
1: Load configuration stream from backup boot flash
Note: The new FPGA configuration stream is loaded into the FPGA at the next power-
up of the payload.
Bit 0: Default/backup boot flash selection
0: Boot from default boot flash
1: Boot from backup boot flash
Note: The newly selected boot flash is connected to the payload immediately, which
means that the writing to the flash is possible. Its image is executed after the next
power-up or cold reset of the payload.
The System Boot Options parameter #96 is non-volatile. During blade production, its data is
initialized to 0xFF and its state is set to invalid. Its parameter data remains preserved after IPMC
power cycles and firmware upgrades.