Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 256)

Supported IPMI Commands
ATCA-7480 Installation and Use (6806800T17A) 256
8.3.2.1 Set Feature Configuration
This command can be used to enable/disable features configurations within the IPMC during
runtime.
Table 8-24 Set Feature Configuration Command
Byte Data Field
Request Data 1 LSB of Artesyn IANA Enterprise Number. A value of CDh shall be
used.
2 2nd byte of Artesyn IANA Enterprise Number. A value of 65h
shall be used.
3 MSB of Artesyn IANA Enterprise Number. A value of 00h shall
be used.
4 Feature Selector. For details, see Table 8-25 .
5 Feature Configuration
Bit [7-0]: Feature Selector = E0h, E1h
00h = disabled
01h = enabled
02h - 0ffh = reserved
Bit [7-0] Feature Selector = 03h:
00h-FFh: Debounce timer timeout value in 100ms
6 Persistency / Duration
00h = volatile. Actual duration depends on implementation.
01h – FFh = reserved
Response Data 1 Completion Code. Generic plus the following command-
specific completion codes:
80h = feature selector not supported.
81h = feature configuration not supported
83h = configuration persistency / duration not supported
2 LSB of Artesyn IANA Enterprise Number. A value of CDh shall be
used.
3 2nd byte of Artesyn IANA Enterprise Number. A value of 65h
shall be used.
4 MSB of Artesyn IANA Enterprise Number. A value of 00h shall
be used.