Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 19)

ATCA-7480 Installation and Use (6806800T17A) 19
About this Manual
Overview of Contents
This guide is intended for users qualified in electronics or electrical engineering. Users must
have a working understanding of Peripheral Component Interconnect (PCI), AdvancedTCA®,
and telecommunications.
The manual contains the following chapters and appendices:
 About this Manual on page 19 , lists all conventions and abbreviations used in this manual
and outlines the revision history.
 Safety Notes on page 25 , lists safety notes applicable to the blade.
 Sicherheitshinweise on page 31 , provides the German translation of the safety notes
section.
 Introduction on page 37 , describes the main features of the blade.
 Hardware Preparation and Installation on page 43 , outlines the installation requirements,
hardware accessories, switch settings, installation and removal procedures.
 Controls, Indicators, and Connectors on page 65 , describes external interfaces of the blade.
This includes connectors and LEDs.
 BIOS on page 173 , describes the features and setup of BIOS.
 Functional Description on page 83 , describes the functional blocks of the blade in detail.
This includes a block diagram, description of the main components used and so on.
 Maps and Registers on page 99 , provides information on the maps and registers of the
blade.
 Serial Over LAN on page 223 , provides information on how to establish a serial-over LAN
session on your blade.
 Supported IPMI Commands on page 229 , lists all supported IPMI commands.
 IPMI Feature Set on page 279 , provides information about controlling via IPMI.
 Replacing the Battery on page 323 , provides the battery exchange procedures.
 Related Documentation on page 327 , provides links to further blade-related
documentation.