2 get serial output command, Table 8-21, Request data of get serial output command – Artesyn ATCA-7480 Installation and Use (February 2015) User Manual
Page 254: Get serial output command, Supported ipmi commands
Supported IPMI Commands
ATCA-7480 Installation and Use (6806800T17A)
254
8.3.1.2
Get Serial Output Command
The Get Serial Output Command provides a way to determine which serial output source goes
to a particular serial port connector.
8.3.1.2.1 Request Data
The following table lists the request data applicable to the Get Serial Output command.
2
LSB of Artesyn Embedded Technologies IANA Enterprise number.
3
Second byte of Artesyn Embedded Technologies IANA Enterprise number.
4
MSB of Artesyn Embedded Technologies IANA Enterprise number.
Table 8-20 Response Data of Set Serial Output Command (continued)
Byte
Data Field
Currently, only BIOS output is supported.
Table 8-21 Request Data of Get Serial Output Command
Byte
Data Field
1
LSB of Artesyn Embedded Technologies IANA Enterprise number. A value of 0xCD has
to be used.
2
Second byte of Artesyn Embedded Technologies IANA Enterprise number. A value of
0x65 has to be used.
3
MSB of Artesyn Embedded Technologies IANA Enterprise number. A value of 0x00 has
to be used.
4
Serial connector type
0: Faceplate connector
1: Backplane connector
All other values are reserved.
Note: Only the faceplate connector is supported. No connector on the RTM available.