Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 225)

Serial Over LAN
ATCA-7480 Installation and Use (6806800T17A) 225
Sample Procedure
To set the IP address:
1. Establish an IPMI connection to the blade.
2. Set LAN Configuration Parameter Set In Progress Lock.
ipmicmd -k "f 0 c 1 1 0 1" smi 0
3. Set LAN Configuration Parameter Set IP (172.16.10.11 on channel 5).
ipmicmd -k "f 0 c 1 1 3 ac 10 0a dd" smi 0
4. Set LAN Configuration Parameter Set In Progress Commit.
ipmicmd -k "f 0 c 1 1 0 2" smi 0
7.3.2 Using ipmitool
The example below shows how to setup a LAN configuration parameter for a potential SOL
session with ipmitool for base 0 (channel 5).
n0s70:~ #
ipmitool lan set 1 ipaddr 172.16.0.221
Setting LAN IP Address to 172.16.0.221
n0s70:~ #
The following example shows how to query the LAN parameters that are currently in use for a
potential SOL session for base 0 (channel 1) and base 1 (channel 2):
root@localhost:~# ipmitool lan print 1
Set in Progress : Set Complete
Auth Type Support :
Auth Type Enable : Callback :
: User :
: Operator :
: Admin :