Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 253)

Supported IPMI Commands
ATCA-7480 Installation and Use (6806800T17A) 253
8.3.1.1 Set Serial Output Command
The Set Serial Output command selects the serial port output source for a serial port
connector.
8.3.1.1.1 Request Data
The following table lists the request data applicable to the Set Serial Output command.
8.3.1.1.2 Response Data
The following table lists the response data applicable to the Set Serial Output command.
Table 8-19 Request Data of Set Serial Output Command
Byte Data Field
1 LSB of Artesyn IANA Enterprise number. A value of 0xCD has to be used.
2 Second byte of Artesyn Embedded Technologies IANA Enterprise number. A value of
0x65 has to be used.
3 MSB of Artesyn Embedded Technologies IANA Enterprise number. A value of 0x00 has
to be used.
4 Serial connector type
0: Faceplate connector
1: Backplane connector
All other values are reserved.
Note: Only the faceplate connector is supported. No connector on the RTM available.
5 Serial connector instance number. A sequential number that starts from "0".
6 Serial output selector
0: BIOS
2: IPMC debug console
All other values are reserved.
Table 8-20 Response Data of Set Serial Output Command
Byte Data Field
1 Completion code