Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 238)

Supported IPMI Commands
ATCA-7480 Installation and Use (6806800T17A) 238
3 Block Selector
Zero based index of the 16-byte block which you want to write to.
Index 0 refers to the first block of 16 bytes, which includes the first two
bytes that indicate the boot parameter data size.
Depending on the total length of the boot option data, your software
may need to write several blocks of 16 bytes in a row, each individually
addressed using the block selector.
4 .. n (n <= 19) Data that you want to write into the addressed block. This will be a
chunk of the boot parameter data. If less than 16 bytes are written,
then only the provided data is written, the remaining bytes in the
addressed storage area block are left unchanged.
Response Data
1 0x00: Write successful
0x80: Boot parameter storage not supported by the IPMC
0x81: Storage area is locked by another software entity
0x82: Illegal write-access
0xC9: Block selector is outside of the allowed range.
Table 8-13 System Boot Options Parameter #100 - GET Command Usage
Byte Description
Request Data
1 Bit 7: reserved. Set to "0".
Bits 6..0: must contain the value: "100", indicating this OEM system
boot option.
2 Set Selector
0: User area
1: Default area
3 Block Selector
Zero based index of the 16-byte block which you want to read from.
Index 0 refers to the first block of 16 bytes, which includes the first two
bytes which indicate the boot parameter data size.
Response Data
Table 8-12 System Boot Options Parameter #100 - SET Command Usage (continued)
Byte Description