6 module identification register, 7 version register, 8 serial redirection control register – Artesyn ATCA-7480 Installation and Use (February 2015) User Manual
Page 129: Table 5-39, Module identification register, Table 5-40, Fpga version register, Table 5-41, Maps and registers
Maps and Registers
ATCA-7480 Installation and Use (6806800T17A)
129
5.1.6
Module Identification Register
The Module Identification Register identifies the ATCA-7480 blade.
5.1.7
Version Register
The version register provides the version of the FPGA bit stream. The initial value starts at 0x01
and will be incremented with each new release.
5.1.8
Serial Redirection Control Register
BIOS sets the corresponding bit, which is used for serial redirection. The IPMC uses this
information to route the corresponding port to serial IPMC interface in case of SOL.
Table 5-39 Module Identification Register
Address Offset: 0x00
Bit
Description
Default
Access
15:0
ATCA-7480 Blade Module Identification
0x7480
r
Table 5-40 FPGA Version Register
Address Offset: 0x02
Bit
Description
Default
Access
7:0
Specifies FPGA version
0x1 (Initial Value)
r
BIOS should never set both status bits.