Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 289)

IPMI Feature Set
ATCA-7480 Installation and Use (6806800T17A) 289
9.2.3.2 Updating ipmitool
The ipmitool HPM update requires two steps for an update.
Procedure
1. Upgrade the component.
prompt->ipmitool hpm upgrade
2. Activate the component.
prompt-> ipmitool hpm activate
9.2.3.3 Upgrading Interfaces
The HPM.1 upgrade supports three different interfaces for upgrading the firmware. These are
KCS, IPMB-0, and LAN over BASE. The LAN interface is fully supported even if the payload is not
powered on (M4). The BASE Ethernet controller is powered with management power.
9.2.3.3.1 KCS
The standard way to upgrade the firmware of the payload is through the KCS interface. The
images and the ipmitool need to be on the payload to upgrade.
Example:
prompt>ipmitool hpm upgrade
9.2.3.3.2 IPMB-0
This interface represents the backplane IPMI bus and allows remote firmware upgrade. The
count of the simultaneous upgrades is limited because of the bus speed.
Examples:
 From shelf manager:
prompt>ipmitool -t 0x92 hpm upgrade
 with RMCP:
prompt>ipmitool -I lan -H 192.168.34.8 -U Administrator -P
Administrator -t 0x92 hpm upgrade