Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 135)

Maps and Registers
ATCA-7480 Installation and Use (6806800T17A) 135
0x5 S3 One or more of these voltages have failed:
12V, 5V aux, VPP or VDD
0x7 TRACK_MASTE
R_ON Timeout (debug disabled) after 280ms. Tracked voltages are
not good.
Other cause: 12V or 5V aux power failure
0x8 VCCIN_ENABL
E Timeout (debug disabled) after 280ms. VCCIN voltages are
not good.
Other cause: One or more voltages have failed, which have
been already enabled and sampled good.
0x9 VCCIO_VPP_E
NABLE Timeout (debug disabled) after 280ms. VCCIO and VPP
voltages are not good.
Other cause: One or more voltages have failed, which have
been already enabled and sampled good.
0xA VDDQ_ENABL
E Timeout (debug disabled) after 280ms. VDD voltages are not
good.
Other cause: One or more voltages have failed, which have
been already enabled and sampled good.
0xB VP12_ON Timeout (debug disabled) after 280ms. 12V or 5V aux
voltages are not good.
0xC VTT_ENABLE Timeout (debug disabled) after 280ms. VTT voltages are not
good.
Other cause: One or more voltages have failed, which have
been already enabled and sampled good.
0xD WAIT_100MS One or more voltages have failed, which have been already
enabled and sampled good.
0xE WAKE_UP Timeout. Board does not wake up within 5s
Other - These values will never occur.
Table 5-48 Payload Power Failure States (continued)
State
Coding State
Name
Description