Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 288)

IPMI Feature Set
ATCA-7480 Installation and Use (6806800T17A) 288
BANK : M - Operational
Firmware Name : PYLD F/W
Firmware Version : 1.0.00000001
BANK : N - Rollback
Firmware Name : PYLD F/W
Firmware Version : 1.0.0000000A
********************[[[[[ REPORT END ]]]]]********************
9.2.3 Firmware Upgrade Tool
The primary update mechanism for the ATCA-7480 blade is the FCU tool, which is delivered
with the BBS package for the blade. However, the ATCA-7480 blade family also supports
upgrades with the ipmitool. Artesyn recommends to use the Pigeon Point System modified
Ipmitool 1.8.13-pps2 or later versions.
9.2.3.1 Installing ipmitool
In case of ipmitool 1.8.13-pps2 is already installed with your BBS package, the following
installation is not needed anymore.
Procedure
1. Get the Pigeon Point System ipmitool from the package (ipmitool-1.8.13-pps-
2.tgz).
2. Extract the ipmitool-1.8.13-pps-2.tgz file.
prompt>tar -xzvf ipmitool-1.8.13-pps-2.tgz
3. Go to the directory where ipmitool is extracted.
prompt>cd /Ipmitool-1.8.13-pps-2
4. Build the ipmitool.
prompt>./configure && make && make install