Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 175)

BIOS
ATCA-7480 Installation and Use (6806800T17A) 175
A NULL-Modem cable is available as accessory kit for the blade. It converts the RJ-45 connector
to a standard DSUB connector which can be connected to a remote terminal. The following
communication parameters are used, by default:
 Baud rate: 115200
 Flow control: None
 VT-100
 8 data bits
 No parity
 1 stop bit
6.2.3 Connecting to the Blade
Procedure
In order to connect to the blade using the serial console redirect feature, proceed as follows:
1. Configure terminal to communicate using the same parameters as in BIOS setup.
2. Connect terminal to NULL-modem cable.
3. Connect NULL-modem cable to COM port of the blade.
4. Start up the blade.
6.3 Changing Configuration Settings
When the system is switched on or rebooted, the presence and functionality of the system
components is tested by Power-On Self-Test (POST).