Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 212)

BIOS
ATCA-7480 Installation and Use (6806800T17A) 212
6.11.2 IPMI Error Logging
BIOS generates status events like Firmware Progress events and error events.
The table below shows all BIOS supported IPMI sensors and their possible events.
Table 6-19 BIOS Supported IPMI Events
Sensor Event
System Firmware
Progress (0Fh) Offset 00h System Firmware Error
Supported Event Data2:
00h unspecified Error
01h No system memory
02h No usable system memory
03h SATA device failure
07h No console in found
0Ah No console out found
0Bh Firmware ROM corrupted
FDh OEM Error Extension
Supported Event Data3 (FDh OEM Error Extension)
21h CPU Built In Self Test (BIST) Error
30h Exception Divide Error
31h Exception Invalid Opcode
32h Exception Stack Fault
33h Exception GP Fault
34h Exception Math Error
35h Exception Alignment Check
36h Exception Machine Check
50h IPMI Boot Parameter Default Area Read Error
51h IPMI Boot Parameter Default Area Locked
52h IPMI Boot Parameter Default Area Checksum Error
53h IPMI Boot Parameter User Area Read Error
54h IPMI Boot Parameter User Area Locked
55h IPMI Boot Parameter User Area Checksum Error
56h IPMI Boot Parameter User Area Write Error
70h Front Panel Network not detected
71h Base Network not detected
72h Fabric Network not detected
73h Accelerator Device not detected
74h RTM SAS Controller not detected
75h RTM Network not detected
76h RTM PCI Bridge not detected
80h Front Panel Network reduced PCI performance