4 establishing an sol session – Artesyn ATCA-7480 Installation and Use (February 2015) User Manual
Page 227

Serial Over LAN
ATCA-7480 Installation and Use (6806800T17A)
227
RMCP+ Cipher Suites : 1,2,3,3
Cipher Suite Priv Max : Not Available
root@localhost:~#
7.4
Establishing an SOL Session
Procedure
To establish a SOL session:
1. Make sure that the requirements detailed above are fulfilled.
2. Compile and install the ipmitool on your target, which is destined for opening the
SOL session on the ATCA-7480. For details refer to
.
3. Apply an IP address to the ATCA-7480 SOL interface. For details, see to
4. Change user and password, if necessary.
Default user is "soluser" and password is "solpasswd".
5. Configure the network between the ATCA-7480 and your target, which is destined
for opening the SOL session, so that the SOL IP address is accessible.
6. Start ATCA-7480 SOL session on your target with the ipmitool and the configured
IP address for the ATCA-7480 SOL interface.
ipmitool -C 1 -I lanplus -H 172.16.0.221 -U soluser -P
solpasswd -k gkey sol activate