Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 53)

Hardware Preparation and Installation
ATCA-7480 Installation and Use (6806800T17A) 53
2.5 Installing the Blade Accessories
The following additional components are available for the blade:
 Dual Inline Memory Module (DIMM)
 MO297 SSD Module
 Rear transition modules
They are described in detail in the following sections. For order numbers, refer to section
Ordering Information on page 39 .
2.5.1 DIMM Memory Modules
The blade provides 16 memory slots for main memory DIMM modules of type DDR4 VLP. You
may install and/or remove DIMM memory modules in order to match the main memory size to
your needs. The corresponding installation/removal procedures are described in this section.
For the location of the DIMM Memory modules, see Figure "ATCA-7480 Blade Layout" on page
50 .
SW3.3 Debug Output to Serial Console OFF [SW3.4, SW3.3]
00 - Normal operation,
01- Load Bios Defaults,
10 - Crisis recovery,
11 - Pot80 to COM1
SW3.4 Load BIOS defaults OFF
Table 2-7 Switch SW3 Settings (continued)
Switch Function Default