Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 55)

Hardware Preparation and Installation
ATCA-7480 Installation and Use (6806800T17A) 55
Only qualified DDR4 DIMMs (Single Ranked or Dual Ranked RDIMM) are allowed; because of
the thermal limit/budget of the blade and the high variation of the power consumptions of
different DIMM types. For thermal reasons, no 4-rank DIMMs and no dual-Die DIMM are
allowed.
Installation Procedure
To install a DIMM module, proceed as follows:
1. Remove blade from system as described in Installing and Removing the Blade on
page 58 .
2. Open locks of memory module socket.
3. Press module carefully into socket.
As soon as the memory module has been fully inserted, the locks automatically
close.
4. If applicable, repeat steps 2 to 3 to install further modules.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.