Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 261)

Supported IPMI Commands
ATCA-7480 Installation and Use (6806800T17A) 261
5 Bit [7] Graceful Reboot Request
If set to 1, indicates that the payload is requested to initiate the
graceful reboot sequence.
Bit [6] Diagnostic Interrupt Request
If set to 1, indicates that a payload diagnostic interrupt request
has arrived.
Bit [5] Shutdown Alert
If set to 1, indicates that the payload is going to be shutdown.
Bit [4] Reset Alert
If set to 1, indicates that the payload is going to be reset.
Bit [3] Sensor Alert
If set to 1, indicates that at least one of the IPMC sensors
detects a threshold crossing.
Bits [2:1] Mode
The current IPMC modes are defined as:
0: Normal
1: Standalone, for a description refer to
Table 8-28
2: Manual Standalone, for a description refer to Table 8-28
Bit [0] Control
If set to 0, the IPMC control over the payload is disabled.
6 Bits [4:7] Metallic Bus 2 Events
These bits indicate pending Metallic Bus 2 requests arrived
from the shelf manager
0: Metallic Bus 2 Query
1: Metallic Bus 2 Release
2: Metallic Bus 2 Force
3: Metallic Bus 2 Free
Bits [0:3] Metallic Bus 1 Events
These bits indicate pending Metallic Bus 1 requests arrived
from the shelf manager:
0: Metallic Bus 1 Query
1: Metallic Bus 1 Release
2: Metallic Bus 1 Force
3: Metallic Bus 1 Free
Table 8-29 Get Status Command Description (continued)
Type Byte Data Field