Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 56)

Hardware Preparation and Installation
ATCA-7480 Installation and Use (6806800T17A) 56
Removal Procedure
To remove a DIMM module, proceed as follows:
1. Remove blade from system as described in Installing and Removing the Blade on
page 58 .
2. Open locks of socket at both sides.
The memory module is automatically lifted up.
3. Remove module from socket.
4. Repeat steps 2 to 3 in order to remove further memory modules.
2.5.2 SSD Carrier and MO297 SSD Modules
ATCA-7480 provides a modular solution for up to three MO297-A compliant SSDs. Each SSD is
connected to the Intel Wellsburg PCH via a SATA interface. The modular approach consists of a
riser card, which provide up to three sockets for SSDs and the MO297-A compliant SSDs.
The SD module is an accessory kit and is not part of the default ATCA-7480. The following
procedure describes the steps to install/remove the MO297-A compliant SSD module.
Before mounting the storage on ATCA-7480, the riser card and SSDs should be pre-
mounted.