Artesyn ATCA-7480 Installation and Use (February 2015) - Manual (Page 49)

Hardware Preparation and Installation
ATCA-7480 Installation and Use (6806800T17A) 49
The blade provides two independent power inputs according to the AdvancedTCA
Specification. Each input has to be equipped with an additional fuse of maximum 90 A located
either in the shelf where the blade is installed or the power entry module (PEM).
The power consumption has been measured using specific boards in a configuration
considered to represent the worst-case (maximum memory population, 3x MO297 SSD
modules, with RTM-ATCA-748X-40G and QSFPs) and with software simultaneously
exercising as many functions and interfaces as possible. This includes a particular load
software provided by Intel designed to stress the processors to reach their theoretical
maximum power specification.
Any difference in the system configuration or the software executed by the processors may
affect the actual power dissipation. Depending on the actual operating configuration and
conditions, customers may see slightly higher power dissipation, or it may even be
significantly lower. There is also a dependency on the batch variance of the major
components like the processor and DIMMs used. Hence, Artesyn does not represent or
warrant that measurement results of a specific board provide guaranteed maximum values
for a series of boards.