Viewlinx ir tab – ClearOne NetStreams DigiLinX Dealer User Manual
Page 87
Editing Devices
5-17
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 5-15
ViewLinX IR Tab
The IR tab allows you to configure how DigiLinX responds when it receives a source or macro IR command.
By default, ViewLinX is configured to allow IR pass through the network to the currently selected source.
Network IR must be disabled if you do not want IR to pass from the selected ViewLinX. You can configure
source and macro assignment. Table 5-10 provides information on the fields available for editing the
ViewLinX IR tab.
5.
After adjusting information on the IR page, select Apply.
6.
Select Relay.
The Relay tab appears as shown in Figure 5-16.
Table 5-10
ViewLinX IR Tab
Tab
Selection Description
IR
Enable IR Network Pasthrough
Enables IR network passthrough for ViewLinX.
Source <#>
Sets the device for DigiLinX to select when it receives the
source IR command.
User <#>
Enables the macro selected when DigiLinX receives an IR
macro command.