Programming hard buttons, Programming hard buttons -82 – ClearOne NetStreams DigiLinX Dealer User Manual
Page 152
DigiLinX Dealer Setup Version 2.35.00
5-82
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
5.
Select the IR tab. The IR tab appears as shown in Figure 5-69.
Figure 5-69
IR tab
The fields available for editing the IR tab are described in Table 5-55.
Table 5-55
IR tab
6.
After adjusting information on the IR, select Apply.
Programming Hard Buttons
You have the option of programming the Audio button on the TouchLinX to act as one of the phantom buttons
you configure for ControLinX (see ControLinX on page 5-84).
1.
Select the Hard Buttons tab.
Hard button information for the TouchLinX displays in the right side of the window (see Figure 5-70).
Tab
Selection Description
IR
Enable IR Network Pasthrough
Enables IR network passthrough for TouchLinX.
Source <#>
Sets the device for DigiLinX to select when it receives the
source IR command.
User <#>
Enables the macro selected when DigiLinX receives an IR
macro command.