Theaterlinx ir tab – ClearOne NetStreams DigiLinX Dealer User Manual
Page 205
Editing Devices
5-135
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 5-115
TheaterLinX IR Tab
The IR tab allows you to configure how TheaterLinX responds when it receives a source or macro IR
command. By default, TheaterLinX is configured to allow IR pass through the network to the currently
selected source. Network IR must be disabled if you do not want IR to pass from the selected TheaterLinX.
You can configure source and macro assignment. Table 5-94 provides information on the fields available for
editing the TheaterLinX IR tab.
8.
After adjusting information on the IR page, select Apply.
9.
Select Relays.
The Relays tab appears as shown in Figure 5-116.
Table 5-96
TheaterLinX IR Tab
Tab
Selection Description
IR
Enable IR Network Pasthrough
Enables IR network passthrough for TheaterLinX.
Source <#>
Sets the device for DigiLinX to select when it receives the
source IR command.
User <#>
Enables the macro selected when DigiLinX receives an IR
macro command.