ClearOne NetStreams DigiLinX Dealer - Manual (Page 300)

DigiLinX Dealer Setup Version 2.35.00
15-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
Figure 15-1 DigiLinX and a Home Network
NOTE: This is the recommended method of integrating an SMM100 with a home
network.
Step 1: Configure the SMM100 with DigiLinX Dealer Setup
The SMM100 ships with an IP address of 10.15.1.25. This address can be changed
from DigiLinX Dealer Setup by selecting Show Advanced Options on the Info tab.
The steps to configure an SMM100 in DigiLinX Dealer Setup are similar to those of
other media servers. Please follow procedures in this section to configure the SMM100
for use with a DigiLinX network. You must update the devices in Dealer Setup before
proceeding.
All IP addresses for the home network, static devices, and DigiLinX devices must have
the same IP addressing scheme and the same subnet mask for the devices to
communicate. NetStreams recommends a Class C subnet mask of 255.255.255.0. Most
home routers use a Class C address.
Adding an SMM100 to a Project
To add an SMM100 to a project, complete the following steps:
1. Open DigiLinX Dealer Setup.
TouchLinX TouchLinX
SpeakerLinX
PowerLinX
PowerLinX
16/4 or 14/4 16/4 or 14/4 16/4 or 14/4
Speakers
SwitchLinX
SMM100 Switch/Router
Computer Computer
Network Access
Storage Drive
Cable
Modem
Ethernet CAT5E
Ethernet CAT5 Ethernet CAT5E Ethernet CAT5E
Ethernet CAT5 Ethernet CAT5 Ethernet CAT5 Ethernet CAT5E
Ethernet
CAT5 Ethernet
CAT5
16/4 or 14/4
USB Drive
Home Network