Touchlinx info tab – ClearOne NetStreams DigiLinX Dealer User Manual
Page 150
DigiLinX Dealer Setup Version 2.35.00
5-80
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
installation for service or upgrading devices, you have access to this information in the project file. Table 5-
52 provides information on the fields available on the Info tab.
2.
After adjusting information on the Info page, select Apply.
3.
Select the User Interface tab.
User interface information for the TouchLinX displays in the right side of the window (see Figure 5-67).
Figure 5-67
TouchLinX User Interface tab
Table 5-52
TouchLinX Info Tab
Tab
Selection Description
Info
Current IP Address
Shows the current IP address of the TouchLinX.
Current Subnet Mask
Shows the current subnet mask of the TouchLinX.
Device Type
The type of DigiLinX device that this is.
Model Number
The NetStreams TouchLinX model number: TL380, TL430,
or TL700.
Firmware Version
What firmware version the device is currently running on the
TouchLinX.
Device Name
Descriptive name the installer assigned to the device when
creating the project.
Override
Changes the default device name. Keep unchecked in most
instances.
Serial Number
Serial number of the TouchLinX.
Device Comments
Indicate where the device is installed so that if you need to
return to the installation for service or upgrading devices, you
can have access to this information in the project file.
Device Summary
Room Name
The name of the room where the TouchLinX resides.
Show Advanced Options
Normally used for advanced configurations. Typically, the
installer will not use this screen.