Speakerlinx, Speakerlinx -68 – ClearOne NetStreams DigiLinX Dealer User Manual
Page 138
DigiLinX Dealer Setup Version 2.35.00
5-68
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
6.
Enter the zone names in the Name field.
Table 5-44 provides information on the fields available for editing the Labels tab.
7.
Enter the type in the Type field. For each zone, choose from EOL (end of line resistor), NO (normally open),
or NC (normally closed). When there is no end of line resistor installed, it is mandatory to choose either NO
or NC.
8.
After adjusting information, select Apply.
SpeakerLinX
Adjust the settings for each SpeakerLinX connected to the system.
1.
Click on the SpeakerLinX you want to edit in the project.
The Info tab for the SpeakerLinX displays in the right side of the window (see
Figure 5-55).
Figure 5-57
SpeakerLinX Info tab
The Info tab contains all of the information for the designated SpeakerLinX. There’s a comments field where
you can indicate the location of the device. If you ever need to return to the installation for service or
Table 5-44
Labels Tab
Tab
Selection Description
Labels
Zones
Up to eight zones of security can be defined for the GE
Concord.
Type
For each zone, choose from EOL (end of line resistor), NO
(normally open), or NC (normally closed). When there is no
end of line resistor installed, it is mandatory to choose either
NO or NC.