ClearOne NetStreams DigiLinX Dealer User Manual
Page 48
DigiLinX Dealer Setup Version 2.35.00
3-12
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE:
The EIM splitter is required to install a KeyLinX or IRLinX. It is shipped in the
same box with the KeyLinX and IRLinX.
For more information, see the DigiLinX Installation and Design Guide.
See Figure 3-12 for an example of the completed device information.
Figure 3-12
SpeakerLinX dialog box
If you select the SL250 or 254 you have the option of choosing a speaker model. If the
speaker you are using is not listed you must use generic. This option is designed for
IP-Ready speakers which are specifically labeled by your speaker manufacturer.
Selecting this option loads the filter and crossover arrangements designed by your
speaker manufacturer into the signal processor of the SpeakerLinX, thereby enabling
greater performance out of your speaker.
2.
Select Save & Continue.
Complete the configuration for all SpeakerLinX devices. After finishing the last
SpeakerLinX, you will be prompted for information for each TouchLinX device
(see Figure 3-13).
Figure 3-13
TouchLinX information window
NOTE:
If you want to add groups of SpeakerLinX that play a single stream of music,
refer to Playmates in Chapter 16.