Sending configuration, Chapter 6, Sending configuration -1 – ClearOne NetStreams DigiLinX Dealer User Manual
Page 215
Sending Configuration
6-1
All specifications subject to change without notification. All rights reserved. Copyright © 2007 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Chapter
6
Sending Configuration
Any time you edit device information, the data isn’t applied to the physical device until
you send the configuration.
Sending Configuration Using the Dealer Setup Wizard
To send configuration files to the live devices, complete the following steps:
NOTE:
If you want to edit details of the live devices prior to sending the configuration
out to them, select Cancel and refer to Editing Devices in Chapter 5. You can
return to push the configuration to the live devices by selecting the Send
Config Files button on the bottom of your screen.
1.
Highlight individual devices to send configuration to or use the Select All button to
select all devices to be configured.
2.
Select OK to send the configuration.
The configuration is downloaded, and the selected live devices are restarted. You
are prompted that the configuration is complete (see Figure 6-1).
Figure 6-1
Configuration Complete prompt