Viewlinx audio/video tab – ClearOne NetStreams DigiLinX Dealer User Manual
Page 85
Editing Devices
5-15
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 5-13
ViewLinX Audio/Video tab
Refer to Table 5-8 for a description of the fields on the Audio/Video tab.
3.
Select the Display tab.
The Display tab appears as shown in Figure 5-14.
Table 5-8
ViewLinX Audio/Video Tab
Tab
Selection Description
Audio/Video
Room Name
Name of room that the ViewLinX is in.
Video Output
The type of video output from the ViewLinX: Component,
Component SD Only, Composite, S-Video, VGA, or Wide
XGA or Auto Select (VL9100-CS only). Auto Select causes
the ViewLinX to detect the source signal and output to the
appropriate physical connector on the ViewLinX. Auto
Select also provides the option of running a macro based on
whether the source is component or VGA. This is intended
to switch the display input to the appropriate selection.
Video Delay Factor
The total video processing delay of the display.
Enable Front IR Receiver
Check or uncheck to enable the IR receiver on the front of
the ViewLinX.
Firmware Version
The version of firmware.
Device Name
The name of the device.
Television Driver
The type of driver file for the television.
A/V Receiver Driver
The type of driver file for the A/V receiver.
Who Should Handle Volume?
Choose from Television Driver, A/V Receiver Driver, or
Neither.